Axle Bracket, rear, for combination 4-link and lower coil-over mount or shock mounts. (Use Block #21854 to support the bolt when coil-overs are used.) Holes for 4-link are ½” diameter on 5-1/2″ centers. Designed for 1-3/4″ wide urethane bushings. If your bushings are 1-3/8" wide, spacers can be used to increase the width to 1-3/4". The 3 coil-over holes are 5/8″ diameter on 1″ centers. The lower coil-over hole center is 4-1/2″ below the bottom of the axle tube. Made to fit 3″ or 3-1/4" diameter axle tubes.

Now available with the lower coil over mounting holes 1" lower to use a longer coil over or to mount the upper crossmember a bit lower in the frame.

Nicely laser cut and formed from 3/16" pickled & oiled mild steel.

Priced each.